The main advantage of a cyclonic design is that the vacuum shouldn’t lose suction as the bin fills up with dirt.
And if there’s one repair job that everyone should know how to do, it’s replacing a vacuum drive belt..In this article, we’ll go through a basic process for replacing a belt.
While every vacuum is different, the steps in this article apply to most vacuum cleaners.. What is a Vacuum Belt?.Vacuum belts are rubber belts that drive the rotation of the brush roll.A spinning brushroll agitates dust and dirt, which can then be collected by the vacuum’s suction.
This makes the belt a critical component for ensuring that a vacuum runs smoothly and effective.. Over time, vacuum belts can break or become stretched.This isn’t surprising, as some vacuum belts spin more than 100,000 times per minute!
When a belt becomes damaged, the brush roll won’t turn correctly, which prevents the vac from properly agitating carpet fibres..
Replacing the belt can restore your vacuum’s performance and is surprisingly easy to do.. How to Replace a Vacuum Belt.Do not use detergents or soap..
Remove the post-motor filter from the main body of the vacuum.. Again, rinse with cold water only until the water runs clear..Allow both filters at least 24 hours to fully dry before putting them back into the vacuum cleaner.. Be careful when cleaning the felt filters, as these are easy to damage.
Don’t worry if the filters are discoloured – this is completely normal.Avoid scrubbing the filters as this can cause damage..